DESCRIPTION:
FF-35V2 Prop Version RC Model Designed by: Paul Petty
This Version 2 RC model is inspired by the F-35C Joint Strike Fighter version used by the US Navy. This model is more scale looking in appearance than the Version 1 FF-35 model also available for free on this website.  The fuselage has more 3D details than the Version 1 FF-35 and uses a 7-Inch prop.  The old version 1 plane used a smaller 6-inch prop.  This original RC model design was made with Dollartree Readiboard White Foamboard. If you want a more scale look, you can paint it with Testor's model primer gray model paint. Other materials such as Dollar Store Foamboard, Depron Foam and Fan Fold Foam may be used to make this model.

 

BASIC RC MODEL NOTES:

• Wing Span: 29 Inches (73.66cm)

• Length: 35.95 Inches (91.31cm)

• All Up Weight: 34.00 Ounces (963.89gm) (As Built with Dollartree Foamboard, Depron or Fan Fold will result in much lighter model)

• Servos: 2 Micro 12gm (Metal Gear Recommended)

• Motor: iFlight Xing 2806.5 1800kv Brushless Drone Motor.  (Use a motor that can spin a 7-Inch Prop.

• 4S Lipo Battery 3000mah to 3300mah 70C+

• 60A Cobra Race Wing Brushless ESC (Try to use a BLHELI Firmware ESC)

• Speed: 70+mph (113.4+kph) depending on Moter, Prop and battery used.

• This model uses Quad-Elevons for control surfaces.

• Required Radio: Minimum 4-Channel with Delta Mixing (Recommended 2.4ghz)

• Flight Skill Required: Intermediate to Advanced

• Building Skill Required: Intermediate (not recommended for absolute beginners)

​

​