Can anyone guide me on using the FlySky CT6B transmitter to simulate drones and RC planes in a drone simulator? I have a simulator cable that works properly with T6 Config software, showing correct joystick outputs. However, the transmitter doesn’t connect to the simulator software when I try to simulate a drone. Any suggestions to resolve this issue?
4o
Yeah I try it and thank you so much for your support
Hello Logesh M,
I have not used the specific FlySky CT6B transmitter on a simulator, but I have used similar transmitters. You usually need a computer driver to be able to interface with the computer via USB port to the 5-pin transmitter port. FlySky lists a driver for the CT6B at this link: CT6B-DOWNLOADS | Flysky
After you have the driver loaded and transmitter connected you will need a compatible Flight Simulator. Not all simulators support all types of transmitters. My first guess would be to try and find the "FMS Flight Simulator" or a simulator called "Clearview". I know Clearview is not free, but is fairly low cost. Both of these are mostly for airplanes. There was a drone simulator I used a while back that was also fairly cheap called FPV Freerider. It was pretty good for basic FPV Drone Simulation.
Here is a link to an instructables page that shows you how to setup a similar FlySky radio and simulator.
FlySky FS-i6X Setup With a RC Simulator : 5 Steps - Instructables